REMKO RBW 300 PV, Инструкция по эксплуатации и руководство пользователя, Страница: 33 / 48

Parameter list (expert level) - continued
No. Description Code Para-
meter Value
Range
30 Used storage tank probe solar
n
n01 0 0-bottom/1-top
31 Min. run-time solar pump n02 15 min 1-30 min
32 Start temperature difference solar n03 5 K 0~20 K
33 Night reduction n04 0 0-no/1-yes
34 Start time night reduction n05 00 h 00~23 h
35 End time night reduction n06 06 h 00~23 h
36 Start temperature night reduction n07 70°C 40~90°C
37 End temperature night reduction n08 10°C 1~40°C
38
Max. storage tank temperature for the solar
drainage valve
n09 80°C 50~90°C
39 Max. storage tank temperature solar pump stop n10 84°C 50~90°C
40
Solar pump operation storage tank temperature-
independent
n11 0 0-no/1-yes
41 Start collector temperature solar pump
r
r01 55°C 10~60°C
42 Setpoint kitchen mode r02 45°C 40~48°C
43 Hysteresis setpoint HW water r03 5 K 1~20 K
44 Parallel operation heat pump/heating coil r04 0 0-no/1-yes
45 Switch-on temperature elec. Heating coil r05 55°C 30~90°C
46 Switch-on delay elec. Heating coil r06 200 min 0~450 min
47 Elec. heating coil replaces compressor r07 0 0-no/1-yes
48 Lower heat pump usable limit r08 -5°C -20~10°C
49 Bivalence point elec. heating coil without delay r09 10°C 0~30°C
50 Bivalence point elec. heating coil with time delay r06 r10 25°C 10~40°C
51 Run-time circulation pump r11 60 s 0~255 s
52 Lower heat pump emergency stop usable limit r12 -15°C -5~-30°C
53 Heat limit kitchen mode r13 56°C 50~56°C
54 Setpoint with PV yield r14 45°C 10-60°C
55 Removes on/off switch status
S
S01 Status CL/OP
56 OHP switch (over heat protection) condenser S02 Status CL/OP
57 Not assigned
58 Error output high pressure alarm switch status S04 Status CL/OP
59 Switch status elec. Heating coil S05 Status CL/OP
60 Not assigned
33