REMET CNC RT-690R, Техническая документация инструкция

Страница: 26 / 29

REMET CNC TECHNOLOGY SP. Z O.O.
Page 26 of 28
Producer of machinery and equipment, machining
13. SOLUTIONS FOR EXEMPLARY PROBLEMS
Problem Possible cause Solution
The device does not
draw branches
Blunt knives,
Knives incorrectly moun-
ted
Knives if necessary to
sharpen or put in place
according to instructions
9.
Immersive rollers bloc-
ked.
Retract the material
from rolls.
Flow regulator in posi-
tion 0.
Increase the flow on the
controller.
The outlet pipe does not
eject wood chips
Rotation speed of the
cutting disc is too low.
Increase the speed to
the recommended range
540-1000 rpm
The material is pulled in
inefficiently.
The flow regulator works
at low range.
Increase the flow on the
controller.
Too little oil
in layout.
Increase the amount of
oil in the hydraulic sys-
tem.
Branches are not trunca-
ted correctly
Blunt cutting knives or
damaged edges of bla-
des.
Sharpen or replace bla-
des if necessary.
Wrong cutting knives
Set the blades properly
in relation to each other
according to the instruc-
tions 9.
Metallic or other distur-
bing sounds are heard
during work
Too much contamination
inside the grinder or po-
ssible damage to the be-
aring
Disconnect the shredder
interior after disconnec-
ting the power source.