REMET CNC RT-690R, Техническая документация инструкция

Страница: 19 / 29

REMET CNC TECHNOLOGY SP. Z O.O.
Page 19 of 28
Producer of machinery and equipment, machining
8. ADAPTATION OF THE POWER TRANSMISSION SHAFT
Aby To ensure compatibility with a variety of 3-point fastening systems, the
power transmission shaft may be too long or too short. Really Imporant is that the
transmission of the telescopic shaft through the telescopic shaft takes place freely,
but without shortening to limit the working range. Too long shaft may cause da-
mage to bearings (including cracks in the bearing housing) in both the crusher and
the tractor.
A. Determination of length:
1. It is necessary to remove bystanders and animals from the device area.
2. Connect the chopper to the tractor, without the power transmission shaft.
3. Raise the crusher to equalize the PTO shaft levels.
4. Measure the dimension between the retaining grooves between the PTO
shaft on the tractor and the PTO shaft on the shredder.
5. Measure the same dimensions on a compressed drive system (PTO shaft)
6. If the power transmission shaft exceeds the measured dimension from
point 4, shorten the shaft.
B. Cutting the telescopic shaft of power transmission:
1. Cut the machine dimension (A) to the cut dimension of the drive system
(B) or (B-A). This dimension determines if the drive system is too long.
2. Add an additional inch (25mm) to this dimension so that the system does
not punch to the working dimension, set the cut-off dimension (C).
3. Cut the dimension (C) at both ends with a metal ball. Cut the plastic
sleeves as well.
4. Powstałe Destroy the resulting sharp edges.
5. Assemble the PTO shaft.
6. It should be checked whether the connection of the PTO shaft takes place
freely.