Rem GrainVac VR12, Руководство по эксплуатации

Страница: 34 / 100

4. O
PERATION
REM - G
RAIN
V
AC
VR12
4.6. P
OSITIONING AND
S
ET
-U
P
34 9000-00-0042 R3
Figure 4.2 PTO Attached to Tractor
6. Attach PTO safety shield chain to a mounting point on the tractor (e.g., drawbar
cage or lift arms) .
7. Assess the site while keeping in mind that a truck or grain cart must be able to easily
drive under the auger once in working position (see Figure 4.3).
a. Possible Situation #1:
• If the ground is level and the opening of the bin is within approximately 6” (152
mm) in height to that of the GrainVac inlet:
• Select the 29” (737 mm) stainless steel hose and use its over-center clamp to
attach to the aluminum bin load-out nozzle. Insert the angled end of the load-out
nozzle into the grain so that the sliding air door is not submerged and can easily
be adjusted.
b. Possible Situation #2:
• If the ground is not level and the bin door is not within 6” (152 mm) of the Grain-
Vac inlet height, or the GrainVac has to be parked at some angle to the bin open-
ing:
• Selecting as many 4’ (1219 mm) stainless steel flex hoses as necessary and
using the over-center clamps, attach the flex hoses to the aluminum load-out
nozzle. Insert the angled end of the aluminum load-out nozzle into the grain so
that the sliding air door is not submerged. Adjust the stainless steel hose(s) to
minimize sharp bends or curves. This will maximize capacity and minimize hose
wear.