Rem GrainVac VR12, Руководство по эксплуатации

Страница: 35 / 100

REM - G
RAIN
V
AC
VR12 4. O
PERATION
4.6. P
OSITIONING AND
S
ET
-U
P
9000-00-0042 R3 35
Figure 4.3 Work Area Diagram
Always open the lid on top of the bin or silo to prevent the bin or silo
from crumpling or sucking in due to GrainVac air suction.
8. Once the hose(s) is/are secured in the bin access door, drive the GrainVac to the
grain pile such that the inlet is in line with the hose. Ensure the hoses are positioned
as flat and level as possible.
9. For optimum performance, ensure the GrainVac is level in all directions.
Note: The angle between the GrainVac and the tractor should be as small as possible. A small
angle (or no angle) means less vibration through the tractor and the GrainVac which
ensures longer life of both pieces of equipment.
Note: To obtain the best performance and operational life on hoses, try to avoid sharp angles
and bends.
10. Place all controls in neutral, turn off the PTO, set the park brake, stop the engine,
remove the ignition key, and chock the wheels before proceeding.
11. Release the over-center clamp on the vac body inlet tube and remove the plug.
12. Insert the telescoping inlet into the vac body inlet and lock the over-center clamp of
the vac body inlet. While holding the end of the stainless steel flex hose in line with
the telescoping inlet, slide the telescoping inlet towards the flex hose. Lock the over-
center clamp of the telescoping inlet onto the stainless steel flex hose, and then lock
the over-center clamp that allows the telescoping inlet to slide.