39
This menu is used to set the current time and date.
When this function is active, the controller’s clock changes automatically to and from
DST (Daylight Saving Time).
6.11. - Time and date
6.12. - Daylight saving time
For analysis of the system data it is essential for the time to be set accurate-
ly on the controller. Please note that the clock does not continue to run if the
mains voltage is interrupted, and must therefore be reset.
When active, the display backlight is switched off after 2 minutes of inactivity.
6.13. - Eco display mode
If a message is waiting, the backlight is not switched off.
This menu is used to select the temperature unit that is displayed.
6.14. - Temperature unit
6.15. - Network
6.15.1. - Access Control
6.15.2. - Ethernet
In this menu, the settings of the ethernet connection of the datalogger are set.
Activate or deactivate the ethernet function.
6.15.2.1. - Ethernet
6.15.2.4. - IP Address
6.15.2.5. - Subnet
6.15.2.6. - Gateway
6.15.2.2. - MAC Adress
6.15.2.7. - DNS Server
6.15.2.3. - Auto-Configuration (DHCP)
In this menu, the settings of the ethernet connection of the datalogger can be set.
Displays the individual MAC address of the datalogger.
In this menu, the IP of the gateway for the datalogger can be set.
In this menu, the IP address of the datalogger can be set.
In this menu you can add or remove four users who should have access to the datalogger.
To add a user in the list, select <add user>. The list shows you the last 5 users that tried
to connect to the datalogger. Select a user with OK to grant him access. To revoke access
again choose one of the 4 users from your list and choose <remove user>.
If activated, the datalogger requests IP addresses and network parameters from a DHCP
server.
In this menu the subnet mask of the datalogger can be set.
In this menu, the IP address of the DNS server can be set.
Special functions
Caution
Caution
