17
│
Sentinel Kinetic Advance S, SX - www.regulus.eu
Electrical Installation
Ensure the electrical supply and controls are isolated before removing access covers!
Step 1:
Remove the outer cover by pressing the
tabs either side of the control module and
lifting the cover outwards from the bottom
edge.
Step 2:
Remove the control module by sliding
it upwards and away from the unit.
Step 3:
Remove the two screws on either side
of the access panel. Lift the panel outwards
from the bottom edge to remove
Note:
The access panel is tethered on the left
hand side.
Note:
All printed circuit boards are ESD sensiti-
ve. Always ensure the correct ESD protection is
used (e.g. conductive wrist straps and anti-sta-
tic mats).
Step 4:
Push the locking tab away from the
printed circuit board and slide it outwards to
access the terminals.
Note:
The printed circuit board will relock after
60mm.
