Regency Fireplace Products C34 Classic, Инструкция для владельца и по установке

Страница: 13 / 60

Regency
®
CLASSIC™ C34-11 Direct Vent Freestanding Gas Stove | 13
|
13
owner's information
LIGHTING PROCEDURE
IMPORTANT: The remote control system supplied with this appliance has
several options for starting/operating the appliance using the power button
and ON/OFF key on the hand-held transmitter.
Prior to operating this appliance, please read the remote control operating
instructions (packaged with remote control) to understand how to operate
this remote control system. Option to download remote functions video
with QR code below.
1. Ensure the wall switch/receiver is in the remote position (see Diagram 1).
3 . After approximately 4 seconds the spark ignition system will spark for 60
seconds to light the pilot.
4. The unit will turn on.
Note:
The first try for ignition will last approximately 60 seconds. If there
is no flame ignition (rectification) the board will stop sparking for ap -
proximately 35 seconds. After wait time , the board will start second try
for ignition by sparking for approximately 60 seconds. If there is still no
positive ignition the board will go into lock out.
The system will need to be reset as follows:
a)
Turn the system off using ON/OFF switch or press ON/OFF button - if
using remote.
b) After approximately 2 seconds turn on ON/OFF switch or press ON/OFF
button if using remote.
c)
Repeat step 2.
ON/OFF
Button
Diagram 1
Diagram 2
Set Switch to
Remote
SHUTDOWN PROCEDURE
1.
Turn the wall-mounted switch or remote to the "OFF" position.
2. Press "OFF" on the remote control.
3. Turn the gas control knob to the "OFF" position to turn off the pilot.
Remote shown in Manual Mode on Hi
Proflame
video
2.
Press and release the ON/OFF button on the remote handheld transmit -
ter (see Diagram 2). An audible beep should be heard from the receiver.