Regan Scientific Instruments BOT-3000E, Руководство по эксплуатации

Страница: 18 / 29

16
the last calibration date, as it will become due exactly one
year from that date.
GENERAL NOTES

Each switch press may be followed by a short delay before
the desired action is initiated.

When the device is inactive for a certain time period, the
display will dim. A press of any switch will awaken the
device. After an extended period of inactivity the device will
beep several times, then power down to conserve battery
pack life. Previous test results will be saved.

It is recommended that one dedicated flash drive be used
per each BOT device, to avoid the possibility of overwriting
files created by another device.

The battery pack charger indicator illuminates red during the
charging cycle, and will change to green once the battery
pack is fully charged. The charger may fault if a battery pack
becomes overheated. In this situation, remove the battery
pack from the charger and allow it to cool down completely
before charging again.

Many types of textured or profiled floors can be tested
without problems; however there may be occasional
surfaces that can be quite challenging. These may be in the
form of grates, embossed metal plates, mosaic tiles, random
or patterned textured surfaces often found near pools, spas,
patios, ramps, etc. See Fig. 8 for examples of limitations.

Reconditioning the sensor material manually is not generally
recommended. Using the Regan Scientific Instruments
sensor reconditioning tool may greatly reduce irregular
sanding patterns or techniques.