Regan Scientific Instruments BOT-3000E, Руководство по эксплуатации

Страница: 16 / 29

14
PRINTING

Hardcopies of the most recent test results, calibrations, and
verifications may be obtained from the “PRINT” screen, or
immediately following a test run (Fig.7).

When the thermal paper roll becomes depleted, it may be
easily replaced by gently squeezing the plastic tabs located
on each side of the access cover, and then gently pulling the
hinged cover open. Be sure to remove the plastic core from
the depleted paper roll. A new roll may be dropped in with
the loose end facing up and outward. Allow a small amount
of paper to protrude from the printer while gently closing the
access cover until it snaps closed.

Extra thermal paper may be obtained from Regan Scientific
Instruments, online retailers, or from various office supply
stores.
The paper roll must be 2 ¼” wide, and less than 50 ft.
in total length to fit the printer. Larger diameters rolls may
damage the printer!
NOTE: Most thermal printer paper
printouts will fade or darken over time.

Figure 7