Reflex Fillcontrol Auto 2P, Руководство по эксплуатации

Страница: 52 / 56

Disassembly
52 — English Fillcontrol Auto Make-up and degassing — 06.07.2016 - Rev. B
11 Disassembly
DANGER
Risk of serious injury or death due to electric shock.
If live parts are touched, there is risk of life-threatening injuries.
•
Ensure that the system is voltage-free before installing the device.
• Ensure that the system is secured and cannot be reactivated by other persons.
• Ensure that installation work for the electric connection of the device is carried out by an electrician, and in compliance with
electrical engineering regulations.
DANGER
Risk of serious injury or death due to electric shock
Some parts of the device's circuit board may still carry 230 V voltage even with the device physically isolated from the power supply.
•
Before you remove the covers, completely isolate the device controller from the power supply.
• Verify that the main circuit board is voltage-free.
CAUTION
Risk of burns
Escaping hot medium can cause burns.
•
Maintain a sufficient distance from the escaping medium.
• Wear suitable personal protective equipment (safety gloves and goggles).
CAUTION
Risk of burns on hot surfaces
Hot surfaces in heating systems can cause burns to the skin.
•
Wait until hot surfaces have cooled down or wear protective safety gloves.
• The operating authority is required to place appropriate warning signs in the vicinity of the device.
CAUTION
Risk of injury due to pressurised liquid
If installation or maintenance work is not carried out correctly, there is a risk of burns and other injuries at the connection points, if
pressurised hot water or steam suddenly escapes.
•
Ensure proper disassembly.
• Ensure that the system is de-pressurised before performing the disassembly.
Prior to the disassembly, shut off the lines from the system to the device and de-pressurise the device. Then disconnect the device from
all electrical power sources.
Proceed as follows:
1. Disconnect the device from all electrical power sources.
2. Secure the facility against unintended reactivation.
3. Shut off the make-up line.
4. Shut off the degassing line.
– Fillcontrol Auto 2PS
5. Disconnect the power cable of the device from the power supply.
6. Disconnect all cables from the facility to the device controller.
7. Open the drain cock at the spray tube of the device until the spray tube no longer contains any water.
– Fillcontrol Auto 2PS
8. If necessary, physically remove the device from the system.
The dismantling process is completed.