Reflex Marine FROG-9, Руководство пользователя

Страница: 32 / 64

User Manual FROG-9
Rev 05 Page32
Visual Inspection Checklist Form
Unit No This Inspection Date
Usage Category Last Inspection Date
Installation / Vessel
Avg No of Transfers / Year
Inspect
No Description Comment Pass /
Fail
1. Main Lift-Eye Plug (Critical Part)
Visually inspect in situ for any signs of wear, cracks,
deformation or other damage.
2. Main Lift-Eye Plug M24 Bolts (Critical Part)
Visually inspect the three M24 lifting eye bolts, nuts, split
pins and tamper proof seals that connect the main Lift-
Eye plug to the central column (through the lifting bolt
retaining sleeve) for wear or damage.
3. Back-Up Lift-Eye
Visually inspect for any wear or damage and check that
the split pin and tamper proof seal are intact.
4. Handling Lift-Eye
Visually inspect for any wear or damage and check that
the split pin and tamper proof seal are intact.
5. Seat Base Assembly and the Hydraulic Damper and
Anti-Tilt Assembly
Visually inspect for any wear or damage and ensure that
all bolts, clevis’ and other fasteners are fully secure.
6. M72 Keel Boss and M10 Cross Bolt (Critical Part)
At the bottom end of central column, visually inspect the
M72 keel boss nut and ensure that the M10 cross bolt is
secure c/w split pin and tamper proof seal. Do not go
underneath an active lift.
7. Frame and Buoyancy
Visually inspect for any damage and ensure that all bolts
and fasteners are tight and fully secure.
8. Landing Feet
Examine the feet to ensure that they are in good
condition and that they are properly secured to the
capsule. Do not go underneath an active lift.
Notes:
i. Measure height of foot and replace if under 120 mm
in height
ii. Measure height of inner foot and replace if under
150 mm in height
iii.
Small (20 mm in length) cuts are acceptable but feet
should be replaced when the internal foam becomes
visible
9. Seat Harness Security
Visually inspect the seat harness attachment points and
the harness webbing for any signs of wear, fraying or
damage. Check that attachment points are secure.
10. Seat Harnesses (sit-in)
Check all seat harness buckles to ensure each is
functioning correctly. (Inspector to sit in each seat and
check fastening and unfastening of each harness).
Link to Index