REENTEL Cabking-6v3, Инструкция по эксплуатации

Страница: 9 / 16

9
THE ART OF CABBING
Note: The supplied resin wheels are designed to work exclusively together in sequence
To avoid scratching or other problems, you should change all the resin wheels if you
plan on using different brands.
Using diamond paste for polishing will finish the process for most
stones, resulting in a bright shiny cabochon, however there are
many other polishing powders and pastes available. To polish
your stone, attach the enclosed polishing pad by screwing it into
the end of the right wheel assembly while the machine is turned
off. Then use the enclosed 14,000 mesh diamond paste syringe
and apply to the canvas polishing pad, by spreading small drops
randomly over the surface. Then using circular motions with your
finger rub the diamond compound thoroughly across the surface
of the pad. Now its ready for use. Most polishing compounds do
not require water so you can turn the machine back on and begin
use. If you want to use with water then make sure to aim the
spray tube to center of the disc (FIG. L). Aiming at the center will allow the spinning
motion of the disc to spread the water evenly over the surface. The spray can be
aimed by appropriately twisting and turning the tube as well as the nozzle (FIG K).
This will allow the water to spread over the disc when spinning. Make sure to use a
separate polishing pad for each different kind of polishing compound.
Now that you have domed and polished your stone you can put a flat on
the backside using the full face diamond flat lap (FIG. Z) Attach the lap
by screwing it into the end of the right wheel assembly, while the ma-
chine is off. Again, make sure the water spray is aimed to the center of
the disc. Simply hold the back of your cab on the surface of the diamond
lap until the back flattens evenly. Both the canvas and full face lap can
only be used on the right shaft.
The art of cabbing involves experimentation since every stone is different. As you pro-
gress in your cabbing ability, you may find that different grits are necessary depending
on your stone and application. Ask your dealer about the other available grits for both
electroplated and resin wheels.
Again, this is a very brief and simple introduction to the cabbing process. The enclosed
book (FIG. L) should help you out further in your understanding as well as searching
the internet and talking with your dealer. We also recommend trying to find a local
lapidary club to further your knowledge. As with all stone cutting and cab making, prac-
tice and experimentation are the keys to success.
FIG. L
FIG. K