REENTEL Cabking-6v3, Инструкция по эксплуатации

Страница: 6 / 16

6
8. Connect the water drainage system by attaching the clear tubing to
the rear spout of the drip pans (FIG. C). Secure the connection by
positioning the spring clasp so it covers the spouts. Tug on the
tubes to make sure they are firmly attached.
9. Place the unconnected ends of the clear tubes in a large (5gal)
empty bucket (FIG. D) (not included), or drain hole, or wherever
you would like the dirty water from the pans to drain out. It is im-
portant that you have the drainage tube pointing as downward as
possible from the machine. This will allow gravity to drain the wa-
ter from the drip pans. If you notice the pans filling up with water,
most likely the clear drain tubes are not sufficiently angled down.
You can tilt the drip pans up and shake the tubing to drain. Once
you have this properly set-up you may want to cut the tubing so
there is no excess slack. This will further help to drain the pans.
10. Connect the water intake system by pushing the blue tube into the
open hole of the black T-junction on the base just behind the motor
(FIG. E). Tug on this tubing to verify a secure connection.
11. Make sure pump is not connected to power supply. Connect the
other end of the blue tube to the water pump. Tug on this tubing to
verify a secure connection. Place the pump in a separate large
(5gal) bucket (not included) filled fully with clean water (FIG. F). To
ensure enough water pressure, the length from the bucket to the
unit should not be more than 6 feet. Once you have found a good
length you can cut the blue tubing to this distance.
CONNECTING THE SINGLE-PASS WATER SYSTEM
7. Finally, you can optionally attach the side panels to the hoods. These are
magnetically attached to the hood to make it easy to remove them. Twist
the side spray tubing upwards to easily attach and remove the panels. The
purpose of the side panels is to control splash, so you may prefer not to
use them for easier access to the diamond lap and polishing pad.
FIG. B
FIG. D
FIG. E
FIG. F
The CABKING-6V3 water system is single-pass meaning non-recirculating. Do not
setup the machine as a re-circulating system. Please read further about it in the Parts
& Maintenance section after finishing the set up. Also, note that the color of the tubing
may vary from the pictures.
FIG. C