22
e) "REV" function: reverse setting
It may be necessary to change the direction of rotation of a servo or to reverse the reaction of the speed controller
depending on the model installation position and linkage.
The reverse setting can be made separately for each of the 6 channels of the transmitter.
Proceed as follows:
• If you press the knob (14) briefly, the
MODEL
function will be greyed out.
•
Turn the knob (14) to the left or right until the
REV
function is greyed out, as
shown in the right figure.
• If you press the knob (14) briefly, the channel number 1 will flash at the bottom
of the display.
•
You can select the channel number (1 – 6) and change the desired reverse
setting by turning the knob (14) to the left or right.
"ST" (= "steering") also flashes for channel 1.
"TH" (= "throttle") also flashes for channel 2.
"AUX" (= "auxiliary" = auxiliary channels) also flashes for channels 3 – 6.
• If you press the knob (14) briefly, the current setting for the previously selected channel ("NOR" = normal, "REV" =
reverse) will flash at the bottom right of the display.
•
To change the setting, turn the knob (14).
• If you press the knob (14) briefly, the indication will stop flashing. The current setting is saved.
If desired, you can now select another function to be changed by turning the knob (14).
To exit the setup menu instead, briefly press the "BACK" button (13). The transmitter will emit a short beep,
and the greyed out field will disappear from functions at the top of the display. The transmitter is back in its
normal mode.
