14
e) Pairing the receiver with the transmitter (binding function)
The manufacturer has already paired the included receiver with the transmitter.
However, if you would like to pair another receiver or if you have reset the transmitter to factory settings,
the receiver must first be paired with the transmitter (also known as "binding") before it can respond to the
transmitter's control commands.
Proceed as follows:
•
Disconnect the receiver from the voltage/power supply. Switch off the remote control.
•
Insert the included binding plug (A) into the "BIND" port (19) on the receiver
(B).
•
Connect the receiver to the voltage/power supply (C); power up any chan-
nel (20) of the receiver.
An electronic speed controller with BEC and a suitable rechargeable bat-
tery for driving can typically be used instead of a battery box (C).
•
Turn on the voltage/power supply of the receiver. The receiver LED (22)
will now flash quickly.
•
Press and hold down the "BIND" button (15) on the transmitter, and then
switch on the transmitter.
•
"BIND" will appear at the bottom of the display. Once the transmitter and receiver have found each other, the "BIND"
indication on the transmitter display will disappear (the indication may not appear if the receiver is found quickly).
The receiver LED (22) stops flashing and glows steadily. The receiver is now paired with the transmitter.
•
Disconnect the receiver from the voltage/power supply and unplug the binding plug from the receiver.
•
Switch on the remote control.
•
Connect the receiver to the voltage/power supply and switch it on (battery box or electronic speed controller with
BEC). The receiver LED (22) will glow steadily.
•
The transmitter and receiver are now ready for operation again.
f) Replacing the rubber handle
The rubber handle (10) mounted on the transmitter can be easily replaced with another rubber handle, supplied
separately.
The rubber handles are different sizes so that the transmitter can be held with a larger or smaller hand. The
size is indicated on the rubber handle ("L" = "large", "S" = "small").
If you want to replace the rubber handle, simply remove it from the transmitter (left and right on the handle). Insert
the other rubber handle and push the 6 side retaining lugs into the holes on the transmitter so that the rubber handle
sits flat.
