20
c) "MODEL" function: Selecting model memory
The transmitter has a total of 20 model memories (01 – 20). This provides the opportunity to operate up to 20 car
models.
Please note that a receiver can only be paired with one model memory at a time.
If you have several vehicles, each with its own built-in receiver, first select a model memory and then pair
the receiver with the transmitter. Proceed in the same way for all other models/receivers.
However, if only one receiver is being used for several vehicles for cost reasons, the receiver must be
paired with the transmitter again as a matter of principle after the model memory has been switched over;
see chapter 10. e).
The same typically applies if several different setups (or model memories) are to be used for one vehicle.
Proceed as follows:
•
First turn off the voltage/power supply for the vehicle receiver of the currently selected model memory.
• If you press the knob (14) briefly, the
MODEL
function will be greyed out, as
shown in the right figure.
• If you press the knob (14) briefly, the number of the model memory will flash
at the bottom left of the display.
•
Turn the knob (14) to the left or right to select another model memory.
If you forget to turn off the voltage/power supply for the vehicle receiver of the currently active model
memory, an error message "Turn off the receiver first" will appear on the display.
The model memory cannot be changed (for example, from memory 01 to 02) for safety reasons if the
receiver has not previously been turned off or disconnected from the voltage/power supply.
• If you press the knob (14) briefly, the model memory number will stop flashing; the model memory is selected.
If desired, you can now select another function to be changed by turning the knob (14).
To exit the setup menu instead, briefly press the "BACK" button (13). The transmitter will emit a short beep,
and the greyed out field will disappear from functions at the top of the display. The transmitter is back in its
normal mode.
