22
b) Programming of Transmitter Channels (General)
Before you begin programming, unplug the
rechargeable battery, if connected, from the
QuadroCopter.
Also disconnect the connection cable to the
PC, if connected, from the QuadroCopter.
The channels must be programmed at the
QuadroCopter's flight control first.
LD2 (figure 8, item 1; red LED) shows the
channel to be set. LD1 (figure 8, item 2;
green LED) shows if the teaching process
was successful.
The QuadroCopter flight control is installed
at the centre of the central frame. There
are DIP switches (figure 8, item 3) to set
the desired modes. Put the switch for the
desired mode in the "ON" position. The
following switch assignments are possible:
DIP switches
Flight Control QC 09
1
Parameter Sport-Mode
2
Parameter User-Mode
3
Bootloader mode
4
RC confirmation mode
5
No function
6
No function
When switches 1 and 2 are in the "OFF" position, beginner mode is active.
To programme the remote control, set the DIP switch 4 to "ON". Independently of which remote control mode (modes
1 - 4, also see chapter "Possible control modes") you want to programme, you must observe the following order of
channel assignment and the signals of LD2 (red LED):
Throttle
LD2 flashes (briefly during initialisation) 1x
Yaw
LD2 flashes 2x
Pitch
LD2 flashes 3x
Roll
LD2 flashes 4x
Agility mode
LD2 flashes 5x
Figure 8
Содержание 650
Страница 1: ... QuadroCopter 650 V2 ARF MEMS Item no 27 51 00 Version 10 11 Operating Instructions ...
Страница 30: ...30 l Possible Flight Modes Mode Throttle Yaw Pitch Roll 1 2 3 4 ...
Страница 58: ...58 ...
Страница 59: ...59 ...
