53
18. Maintenance, Care and Repair
a) Regular Cleaning
The QuadroCopter is a very simple but nonetheless well-designed flying device. There are no mechanical parts that
need to be lubricated or require special maintenance. However, after each flight operation you should clean the
QuadroCopter of possible dirt (grass blades, dust etc.).
For cleaning, use a dry or slightly damp cloth and avoid contact between water and the electronics, rechargeable
battery and motors.
Do not fly without covering the electronics. Please ensure that no moisture enters the inner central piece (e.g. wet
grass blades etc.) Never fly when it is raining!
b) Replacing the Rotors
If a rotor is damaged in a crash or other action, replace it immediately. This also applies if there are any fine tears or
grazing in the rotor. Due to the high speed, material parts could come loose if the rotors are damaged and this could
lead to damage to or endangerment of the environment.
To change a rotor, remove the rotor tip with the spring washers and the faulty rotor. Carry out the mounting of the new
rotor as described in the chapter “Final Assembly of the QuadroCopter“, under mounting of the rotors.
Attention!
To avoid negative influence on flight characteristics, motor shafts and rotors must be checked for imbal-
ance and replaced if necessary.
Please observe the rotating direction of the respective motor and the choice of the corresponding rotor
without fail. If these are incorrectly chosen, the model will not be able to fly and will act in an erratic way
when next started! Loss of guarantee/warranty!
c) Replacing a Motor
If a motor is defective (overheating, electrical fault or bearing failure), this must be replaced. For this purpose, carry out
the following steps as specified:
• Remove the rotor from the faulty motor.
• Remove the upper cover, reinforcement plate and the upper part of the grid frame by loosening the upper screws.
Now you have free access to the motor drivers (driver board). You can also carefully remove these from the clamp
for better and easier handling.
• Note down the colours of the motor connecting cable at the soldering points A, B and C and unsolder the cable.
• Loosen the screws of the motor clamp and remove the motor from the motor clamp. Pull the cable through the radial
arm.
• Take the new motor and pull the connecting cable through the radial arm. Bolt down the motor and solder the cable
again following the colour table that you noted down.
Содержание 650
Страница 1: ... QuadroCopter 650 V2 ARF MEMS Item no 27 51 00 Version 10 11 Operating Instructions ...
Страница 30: ...30 l Possible Flight Modes Mode Throttle Yaw Pitch Roll 1 2 3 4 ...
Страница 58: ...58 ...
Страница 59: ...59 ...