Reely 650, Руководство по эксплуатации

Страница: 21 / 60

21
 
9. Checking the Configuration
a) General Information
Please carry out the configuration of the QuadroCopter as described in this chapter. Programming of the channels is
essential, since otherwise the QuadroCopter will not recognise your transmitting equipment. When you have carried
this out, your QuadroCopter is ready to fly.
If you are using a computer remote control, programme it without using a mixer in the standard program.
To correctly assign the control lever and control channels to the desired control commands, the QuadroCopter must be
programmed for the transmitter used. The QuadroCopter's electronic unit stores the channel transmitting each control
command. Generally, you can freely select the assignment of your control levers and switches (as you prefer), but we
recommend that beginners use the suggested examples.
Ex factory, the QuadroCopter is configured to “mode 2”. The examples are for a common assignment used by many
model pilots.
Decide which configuration you wish to program and programme the channels correspondingly. Further possibilities
for control modes 1, 3 or 4 (modes 1, 3 or 4) can be found in the instructions in this chapter under the heading
“Possible Flight Modes”.
For monitoring the configuration, indicating malfunction or operating status, a red and a green LED are installed on the
control board. The respective indications can be seen in the table in the following chapter “safety devices” in this
instruction manual.
When using Multiplex remote control, the servo protocols for all functions (throttle, roll, pitch, yaw, switch-
ing channel for "agility mode") must be switched from "MPX" to "UNI".
If the QuadroCopter cannot be programmed onto your remote control, this may be due to the reverse
function of your remote control. We recommend pressing the reverse switch for the throttle function and re-
trying programming.