STRONG DESIGNS RW EDGE 540V3 30CC
7
• Once the horizontal stabilizer is installed to
the fuselage, center the servo and connect the
servo end with the included hardware.
From the Pro:
It is best practice to use a small
washer on the outside of the ball link on the servo.
This will prevent the
ball joint from
slipping off under
load.
.
Rudder and Tail Wheel
Start by removing all the hinge points from the
rudder.
Coat the pivot of each hinge with petroleum
jelly all the way around working the hinge back
and forth to ensure full
coverage into the
pivot.
NOTE:
Keep clear of the
ribbed portion as this
will prevent adhesion.
You will install the point hinges into the
fuselage side first.
•Mix a small batch of
30 minute epoxy
(about 1 to 2 quarter’s
size)