STRONG DESIGNS RW EDGE 540V3 30CC
18
•Mark all the
cutouts on the cowl.
Then, remove the
cowl and trim using
a rotary tool.
•After the initial cutouts are complete, test fit
and adjust as needed until the cowl fits without
any rubbing and a minimum 1/8” clearance .
From the Pro:
Make only small adjustments at a time
as you can quickly remove too much material.
•With the cutouts finished, make a template for
the lower cowl screws. Align with the screw
hole using one of the
mounting screws before
taping in place.
•Install the cowl, mark the mounting locations,
and remove to drill. Drill a 1/8” hole in each
location.
•Before installing the cowl the final time, install
the top cover for the motor box. Harden the
screw threads with thin CA as you have done for
the servos throughout assembly.
•Install the cowl for the final time using thread
lock compound and bonded washers on all the
screws .
•Finally, you can install the prop and spinner to
finish up the nose.