STRONG DESIGNS RW EDGE 540V3 30CC
6
•Next drop the servo into place and drill for the
servo screws with a 1/16” drill bit.
•Remove the servo and thread a servo screw in
and out of each hole. Then apply 2 drops of thin
CA to each and allow the CA to soak in and fully
cure.
•Next, install the servo with the output to the
rear, pulling the wire lead into the fuselage
from the radio tray.
Then center the
servo and install the
servo horn.
From the Pro:
Use heat shrink tube to secure the
servo lead to the extension
•Assemble the control rods to 5.75” length
making sure the turnbuckle is centered with
room to adjust both ends, and secure the
elevator end.
NOTE:
It is easier to install the rudder,
tailwheel, and pull-pull linkage before mounting
the Horizontal stabs to the fuselage.
•Next, insert the carbon fiber stabilizer tube to
the fuselage.
DO NOT GLUE!
Then locate the stabilizer
hardware.
•Install the stabilizer
halves onto the carbon
fiber tube, and secure
using the screws with a
drop of thread locking
compound on each.
