STRONG DESIGNS RW EDGE 540V3 30CC
3
Wing Assembly
The ailerons arrive pre-hinged. Firmly pull on
the aileron to ensure all hinge points are
secured properly.
From the Pro:
Some pilots prefer to seal the hinge
gap. If you wish to do this, it is best to do it now
before anything is installed to the wing.
•Prepare the aileron servos by installing the
grommets and inserts. Also, secure the
extension to
the lead at this
time.
From the Pro:
Use heat shrink
tube to secure the servo lead
to the extension.
•Next, install the dual control horns into the
pre-cut slots of the ailerons.
•Lightly scuff the glue surface of the horns using
coarse grit sand paper or a rotary sanding tool.
•Using the
included linkage
hardware, join
the two horns as
shown.
•Mix a small batch of 15 min
epoxy and coat the
inside of the slots.
Lightly coat the ends
of the control horns
and insert them into
the slots, angled
toward the hinge line.
•You should have minimal squeeze out and a
small fillet will form at the base of the horns.
Clean up any excess with denatured alcohol.
