RDL-3000
FAMILY
USER MANUAL
70-00158-03-00
Proprietary Redline Communications © 2015
Page
104
of 254
April 17, 2015
802.1Q VLAN ID [0-4095]
: Enter the VID associated with this Group definition.
This field is applied only when 'Tagged' is selected in the Group Tagging Mode field.
Default Priority
: Enter the default 802.1p priority setting.
The default priority value is applied when a Service Group set to Tagged mode (add
VLAN tag) receives a packet with no priority information.
Advanced Service Configuration
The traffic each Service transmits over the wireless interface is monitored to enforce PIR
settings (50 - 100000 Kbps). Traffic statistics are reset at the beginning of each common
one-second clock tick. If the maximum throughput is reached on any Service before the
end of the current interval, that Service is excluded from sending additional traffic until
after the next clock tick.
For example, if a Service transmits its full data allocation in the first 650 ms of the
current metering interval, that Service will not receive any additional bandwidth allocation
until the beginning of the next interval (enforced pause of 350 ms).
When adaptive modulation is enabled, automatic adjustments to the modulation/coding
will result in relative changes to the PIR of all Services and Service Groups using that
wireless link. Incorrect PIR settings may result in excessive latency or dropped packets
(buffer full condition).
Important: The available UL and DL PIR is controlled by the options key.
DL CIR
: Enter the committed information rate for downlink unicast traffic.
UL CIR
: Enter the committed information rate for uplink unicast traffic.
DL PIR
: Enter the peak information rate for downlink unicast traffic.
The maximum available DL PIR setting is controlled by the installed options key
(
).
UL PIR
: Enter the peak information rate for uplink unicast traffic
The maximum available UL PIR setting is controlled by the installed options key
(
).
IMPORTANT NOTICE: Changing Service CIR / PIR for STID Link Templates
Failure to follow proper procedures when changing CIR / PIR settings on services associated
with STID link templates will cause LOSS OF COMMUNICATIONS to all subscribers on the
sector controller. To modify PIR / CIR settings on services for STID links (templates), use only
the approved methods described in the
Section 7.1: Modifying CIR / PIR Settings for Service
QoS Configuration
The RDL-3000 can prioritize wireless traffic based on the 802.1p priority tag.
802.1p Prioritization Enable
: Check this box to enable mapping packets containing
802.1p priority tags to one of four prioritized transmit queues. Each 802.1p priority level
can be mapped to a specific transmit queue. Packets with no priority tag are mapped to
queue '0' (lowest priority).
Priority for 802.1 = [0-7]
: Select the queue to assign each packet containing an 802.1p
priority tag.
Important
: For best operation, it is recommended to use the factory default settings
when enabling 802.1p prioritization. These settings should be changed only by
advanced network administrators after evaluating the predicted effects on network and
wireless traffic.
Controls
Apply
: Click to accept and activate displayed settings.
