Redarc GoBlock PPS12050, Быстрый старт

Страница: 12 / 44

12 | Turn GoBlock On and Off
TURN GoBlock ON AND OFF
GoBlock features an automatic Sleep Mode to save power, and will wake up automatically when a
load or input is detected.
GoBlock can also be turned Off via the Control Button. This disables Bluetooth
®
and disconnects all
input/output sockets so that loads plugged into the GoBlock do not draw power.
NOTE: The Storage Isolation Switch does NOT turn the GoBlock Off — loads may still be powered
via the output sockets if there is any input source.
Do not use the Storage Isolation Switch to turn the GoBlock on/off during normal use. Instead, turn
the unit on/off via the Control Button.
The Control Button turns the
GoBlock on, off, and wakes it
up from Sleep Mode.
Turn the GoBlock On
Make sure the Storage Isolation Switch is turned 'ON'. See 'Storage Isolation Switch' (page 30) .
Press the Control Button once to turn the GoBlock On. GoBlock will beep once and the Battery
Level LEDs will illuminate.
Turn the GoBlock Off
Make sure the Control Button LED is either solid blue or off, then Press and hold the Control
Button for approximately 5 seconds or longer. After a further 3 seconds the Control Button LED
will illuminate white and the Battery Level LEDs will begin to count down. The Battery Level LEDs
will count down from top to bottom. Continue pressing the button until there are three beeps — all
outputs and the Auxiliary Anderson input are now Off.
The count-down can be cancelled at any time by releasing the Control Button.
The Control Button LED is solid white during the
Power Off count-down (press and hold).
CONTENTS