Redarc GoBlock PPS12050, Быстрый старт

Страница: 17 / 44

Charge the GoBlock | 17
Charge From Solar Panels/Blankets
CAUTION
The maximum total output voltage of solar panels connected to the GoBlock must not exceed
32 V. Excessive voltage (> 32 V) from solar panels may damage the GoBlock internal electronics
and could cause the unit to become hot. If overheating or smoke is detected, immediately
disconnect the solar panels.
NOTICE
ƒ
Do not connect solar panels to the 50 A Anderson™ Output on the front of the GoBlock, as
this may damage the unit. ONLY connect solar panels to the Auxiliary Anderson™ Input on
the back of the GoBlock.
ƒ
Do not connect solar panels that have an in-built solar regulator, as it can interfere with the
performance of the GoBlock's internal solar regulator.
Plug the solar panel's Anderson™ connector into the Auxiliary Anderson™ Input on the back of the
GoBlock. An adaptor cable will be required if the panel does not have an Anderson™ type connector.
If using portable/folding solar panels or a solar blanket, position the panels to directly face the sun.
This will ensure that maximum solar energy is collected.
For detailed information about using solar panels with your GoBlock, see page 18 .
Charging from 12 V portable solar panels (or blanket).
12 V
CONTENTS