Red Hat ENTERPRISE LINUX 5 - VIRTUAL SERVER ADMINISTRATION, Руководство по развертыванию

Страница: 200 / 848

Chapter 15. Network Configuration
174
2. Click the
New
button on the toolbar.
3. Select
Modem connection
from the
Device Type
list, and click
Forward
.
4. If there is a modem already configured in the hardware list (on the
Hardware
tab), the
Network
Administration Tool
assumes you want to use it to establish a modem connection. If there are no
modems already configured, it tries to detect any modems in the system. This probe might take a
while. If a modem is not found, a message is displayed to warn you that the settings shown are not
values found from the probe.
5. After probing, the window in
Figure 15.6, “Modem Settings”
appears.
Figure 15.6. Modem Settings
6. Configure the modem device, baud rate, flow control, and modem volume. If you do not know
these values, accept the defaults if the modem was probed successfully. If you do not have touch
tone dialing, uncheck the corresponding checkbox. Click
Forward
.
7. If your ISP is in the pre-configured list, select it. Otherwise, enter the required information about
your ISP account. If you do not know these values, contact your ISP. Click
Forward
.
8. On the
IP Settings
page, select whether to obtain an IP address automatically or whether to set
one statically. Click
Forward
when finished.
9. On the
Create Dialup Connection
page, click
Apply
.
After configuring the modem device, it appears in the device list with the type
Modem
as shown in
Figure 15.7, “Modem Device”
.