RDZ FLOOR-S, Инструкция по установке и техническому обслуживанию

Страница: 14 / 60

US FLOOR / FLOOR
Minichiller inverter Duo
13
7.3 POSITIONING AND MINIMUM TECHNICAL CLEARANCES
7.3.1 Indoor unit
The installation must allow authorized personnel to operate in the
event of maintenance, in an easy manner respecting both the safety
distances between the units and other apparatus that the technical
spaces (expressed in mm) indicated in the table:
(*) Recommended distances for lateral inspection in case of
concealed installation. In case concealed installation, the inspection
side is not required and you can keep up to 5 mm on each side.
MOD. L1* L2* H1
FLOOR/FLOOR-S 06-09/12-16 300 300 300
•
Make sure that the equipment is installed and protected from
the weather elements in a clean and dry location.
•
Place the unit on the wall.
•
The feet should be in horizontal level.
(A) Level
7.3.2 Outdoor unit
All the outdoor units of US series are designed for outdoor installation: any cover over the unit and location near trees (even if
they partially cover the unit) is avoided in order to allow the air recirculation. It is advisable to create a proper basement, with a
size similar to unit foot-print. Unit vibration level is very low: it is advisable however, to fit a rigid rubber band between basement
and unit base-frame. It is also possible to install anti-vibration supports (springs or rubbers) to keep vibrations at a very low level.
Absolute care has to be taken to ensure adequate air volume to the condenser. Re-circulation of discharge air has to be avoided;
failure to observe this point will result in poor performance or activation of safety controls. For these reasons it is necessary to
observe the following clearances (expressed in mm):
MOD. A B* C D E**
06 1500 500 400 400 500
09 1500 500 400 400 500
12 1500 500 400 400 500
16 1500 500 400 400 500
* Minimum clearances recommended for installation
and maintenance.
** Minimum clearances recommended for assistance
and maintenance.