RCA RCU1010, Руководство пользователя

Страница: 17 / 40

17
Your RCU1010’s SmartMacro feature allows you to execute a sequence of commands with one
keypress. A SmartMacro learns any sequence of original remote commands. A total of 20 Learned
commands can be stored under each of the nine available LCD Macro keys. If you program all 20 keys
into a SmartMacro, the Macro is automatically stored after the twentieth Learned command is
completed. The sequence of commands you want a SmartMacro to execute must be programmed in
correct sequential order. Any sequence of commands that you regularly perform can be stored as a
SmartMacro and reduced to a single keypress. You cannot program a Macro within a Macro.
Program a SmartMacro
Example of Programming a Macro
1. Turn on the TV and set it to channel 3.
2. Turn on the satellite receiver and set it to channel 57.
3. Turn on the VCR.
4. Now you’re ready to record your favorite satellite program with just a keypress.
SmartMacro Key Operations
To program a SmartMacro, follow these steps:
1. Gather all your original remotes that contain functions
you would like to add to a SmartMacro.
2. Place the first original remote in the Learning position (see
Learning Tips section on pg. 14). Point the top of the original
remote at the base of the RCU1010 so the IR LED on the
original remote is in line with the RCU1010 Learn sensor,
located at the bottom of the remote. The remotes should be
positioned 2-3 inches apart.
3. Press and hold the SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
4. Release the SETUP key.
5 Press and release the LCD MACRO Key. The Set SmartMacro?
Screen is displayed.
6. Press and release the LCD
OK
key.
7. The touchscreen now displays the SmartMacro Key? Screen.
Press and release the digit key under which you want to store
the SmartMacro (from 1-9).
8 The touchscreen now shows the S-MacroX Learn? Screen.
Press and release the LCD
LEARN key.
9. The S-Macro X Learning Screen now appears on the
touchscreen. Press and hold the key on the original remote
until the LED indicator light on the RCU1010 blinks once.
This process takes 2-3 seconds to complete.
Note:
If there is a problem during the Learning process,
the S-Macro X Error Screen is displayed for three seconds
but remains in the SmartMacro routine and returns to the
S-Macro X Learning Screen. If no Learned command is
detected, the RCU1010 will timeout after 30 seconds.
10. Release the original remote key.
11. Program additional commands in the order you want them
to be stored in the SmartMacro. To add commands to the
SmartMacro, repeat steps 8-9 above, using the original
remotes to program. When finished, press and release the
LCD
OK Key You can store up to 20 learned commands under
one SmartMacro.