RC Systems ViewSmart 1600+, Руководство по эксплуатации

Страница: 95 / 141

UM-1097
Revision B 85
C o n n e c t C OM1 t o C OM2 a n d C OM3 t o C OM4 . 2 o r 4 Wi r e .
C o n n e c t T X A - > R X A a n d T X B - > R X B .
C OM1
T X A
T X B
R X A
R X B
C OM2
R X A
R X B
T X A
T X B
S U C C E S S
C OM3
T X A
T X B
R X A
R X B
C OM4
R X A
R X B
T X A
T X B
F A I L U R E
Figure 62 Serial Port Loop Back Test Menu
7.9 I/O Board Configuration
The board configuration screen shows all connected I/O options. This is also the menu where the user
must go if they want to change the configuration or channel group of an option board. To change the
configuration of an option board
1. Highlight I/O Board Config
2. Press Edit
3. Remove the PGM Jumper (J2) on the option board you wish to configure
4. Press Up, Down and Edit until the desired channel group is displayed
5. Replace the PGM Jumper (J2)
6. Press Next twice
7. Press Edit to accept the changes, and reboot the controller
The Channel group LED should now be illuminated next to the desired channel group.