16
The free ends of the bungee cord coming
from Lark’s Head Hitch on the Wing Tab
should be passed through the slot of the
Wing Tri-glide attached to the Razor Harness
and then run up to the MBP and passed
through the two holes either side of slot B.
The bungee cord can be locked in place with
a simple overhand knot tied on the inside of
the MBP.
The bungee cord should have some tension
on it with the BAT Wing completely deflated
so that it will be held in a streamlined low
profile position when inflated and will pull
tight when deflated.
It will take a little bit of trial and error to get
the length/tension correct so leave the bungee
cords long to begin with and do not tie the
knots too tight so that they can be released
and moved easily if necessary. Once the cor-
rect length is achieved then any excess bun-
gee can be cut off and the ends of the cords
burnt to seal them and the knots snugged
tight.
Step 3: Attaching and Adjusting the BAT Wing Rear Bungee
to the Razor Harness
2 Rigging the Razor BAT Wing
