4
Once your Razor Harness and T Weight System have been set up then you
can attach the BAT Wing to the Harness.
The BAT Wing should be worn with the Primary Wing on the outside and the
Backup Wing on the inside.
This makes finding both the Primary and Backup wing dump valves easier
and allows both to be vented more effectively and the Backup wing is very
well protected.
The design of the BAT wing places the position of
the dump valve and the inflator elbow in a well
protected low profile position between the Side
Mount tanks and the diver’s body.
In addition the outside material of the wing is not
placed between a hard object such as the dump
valve and the ceiling of a cave, or a sharp object
in a wreck for example where it may be more
prone to damage.
In the very unlikely event that the dump
valve or inflator elbow or large diameter
inflation hose should be damaged these
components are easily and cheaply
replaced which is not the case if the
wing material is damaged.
The BAT Wing is supplied with a 19”
long large diameter inflation hose
and an 8” long LPI hose fitted with
a hose hat.
This configuration should fit just
about everyone but shorter large
diameter inflation hoses of 16”
or 13” and shorter LPI hoses of
6” or 4” can be purchased
separately in order to custo-
mize hose lengths if required.
1.2 Overview
1 The Razor BAT Wing
