Raytheon RayChart 620, Руководство по эксплуатации

Страница: 39 / 121

26 RayChart 620
Editing an Existing Route On-Screen
You can edit the current route, even if it is active. You do this using the
same screen you used for entering a new on-screen route.
➤
To add waypoints to the end of an existing route:
1. Press the ROUTE soft key to display the Route menu and the
current route selection.
2. If required, press the SELECT soft key to select a different route.
The Route menu shows the complete list of options when a route is
present, and the route is displayed on the chart if it is in the currently
displayed area.
3. Use the trackpad, or press the ROUTE soft key, to highlight the
MAKE/EDIT option, and press ENTER.
The cursor is connected to the last-placed waypoint with a dotted
line, ready to add further waypoints to the route in the same way as
for a new route.
You can now add, delete or insert waypoints, although you cannot
delete a waypoint if you are tracking towards it.
Note: You can also use this option to delete waypoints that are not part
of the current route, if you have selected the waypoint display option
when you set up your RayChart (see Chapter 6).
➤
To delete a waypoint:
1. Use the trackpad to position the cursor over the waypoint you wish
to delete, until the data for that waypoint is displayed in the object
data box.
2. Press the DELETE WPT soft key.
3. Press ENTER to confirm the deletion, if the waypoint is used in a
route.
The waypoint disappears from the screen. If the waypoint was not
at the end of the route, then the waypoints before and after the
deleted waypoint are connected with a straight line.
➤
To insert an additional waypoint in a route:
1. Position the cursor on (or close to) the line between two existing
waypoints.