Raymarine P70, Инструкция по установке и эксплуатации

Страница: 30 / 104

5.1 Mounting
The product is designed to be flush mounted.
Before mounting the unit, ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the cable will
take.
• Detached the front bezel.
p70 Mounting
D12104-1
p70r Mounting
D12105-1
1. Check the selected location for the unit. A clear, flat area with
suitable clearance behind the panel, is required.
2. Fix the appropriate cutting template supplied with the product,
to the selected location, using masking or self-adhesive tape.
3. Using a suitable hole saw, make a pilot holes in each corner
of the cut-out area.
4. Using a suitable saw, cut along the inside edge of the cut-out
line.
5. Ensure that the unit fits into the removed area and then file
around the cut edge until smooth.
6. Drill four holes as indicated on the template to accept the
securing screws.
7. Peel the backing off of the gasket, and place the adhesive
side of the gasket onto the display unit and press firmly onto
the flange.
8. Connect cables to the unit.
9. Slide the unit into place and secure using screws provided.
Note: Drill, tap size, and tightening torque is dependent on the
thickness and type of material the unit is to be mounted on.
Front bezel
Removing the front bezel
D12032-2
1 2
3 4
Important: Use care when removing the bezel. Do not use
any tools to lever the bezel, doing so may cause damage.
1. Using your fingers pull the bezel away from the unit at the
top and side, as shown in 2.
The bezel will start to come away from the unit at the top
and side.
2. Now pull the bezel away from the unit on the opposite side,
as shown in 3.
The bezel will now come free from the unit, as shown in 4.
30
p70 / p70R