17
5. Connect an RF cable between ‘
Multi S/W IRD1
’ of the
DiSEqC supplier and any ‘
OUT
’ of the multi-switch. (3).
6. Connect an RF cable between ‘
Master IRD
’ of the DiSEqC
supplier and ‘
Satellite
’ of the Master IRD (4).
7. With the system powered:
• Set the ACU to
ON
.
• The IRDs to
OFF
.
• The television receivers to
OFF
.
8. Confirm that the antenna detects and tracks the DirecTV101
satellite.
9. Set the Master IRD to
ON
.
10. Set the Master IRD television receiver to
ON
.
11. Set the remaining IRDs to
ON
.
12. Set the remaining television receivers to
ON
.
The system can now be controlled using the Master IRD.
Note 1: The optimal setting for DirecTV service is; SAT A -
DTV101, SAT A* - DTV119, SAT B - DTV101 and SAT B*
- DTV110#. For full details refer to “HD information” on
page 59.
When using the multi-switch and DiSEqC supplier the power
setting has to be changed for all three satellites (DTV101,
DTV119, and DTV110#) to 18V only. This change can be made
in two places:
•
In the Edit Satellite Information section of the ACU set up
menu. You have to change one satellite at a time and
change the power setting (Voltage) to 18V only. This should
be repeated for all three satellites then saved. You can
press ‘
NEXT
’ on the ACU until you get to the Power Setting
section.
RF1
RF2
Multi-switch
LNB
RHCP/+13V
VHF/UHF
INPUT
POWER
24V DC
LNB
LHCP/ +18V
OUT 1 OUT 2
OUT 3 OUT 4
GROUND
IRD 1
IRD 2
IRD 3
IRD 4
D7962_2
MASTER
Multi S/W
18 V
Antenna
RF 1
Multi S/W
IRD 1
Master
IRD
1
2
3
4
DiSEqC
Supplier
81304_2.book Page 17 Thursday, March 26, 2009 3:59 PM
