14 Raymarine 37STV Satellite TV System
Configuring the system
Your Raymarine Satellite TV system can be connected with
multiple IRDs at the same time to receive pictures in different
cabins offering the maximum choice of channels. In all cases the
ACU must be connected to the RF1 connector of the antenna
base plate. Select the set up for your area of operation from the
following combinations.
North America
The following section shows the set up combinations for North
America.
For information on High Definition (HD) satellite switching and
technical tips refer to “HD information” on page 59.
Single IRD
This is the basic method for connecting your Raymarine 37STV
Satellite TV System.
The 3 m ACU set-top cable should be connected from the
RECEIVER
port of the ACU to ‘
LNB
’, ‘
ANT
’ or ‘
Satellite In
’ on
the rear panel of the IRD.
Twin IRDs (Non HD)
You can connect two IRDs to your antenna as shown in the
diagram above. However, only one of the IRDs can be
configured as a two satellite receiver. The other IRD needs to be
configured as a one satellite receiver.
The two satellite receiver determines which satellite is tracked,
while the other receiver can watch any channel which is
available from the tracked satellite.
RF1
RF2
D10504_1
IRD (not supplied)
RF1
RF2
IRD 1 (not supplied)
IRD 2 (not supplied)
D10579_1
81304_2.book Page 14 Thursday, March 26, 2009 3:59 PM
