Rapid 2005, Инструкция по установке, эксплуатации и обслуживанию

Страница: 74 / 162

B-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
64 of 147
Step 12.3.13
12.4 Inlet Hood Installation
The inlet hood may be installed either onto the inlet of the air handler or to an o u tside w all.
12.4.1 Inlet Hood Installation to Wall
Use lagbolts to install the inlet hood to an exterior w all. Once the inlet hood is in place, the edges m u st be
sealed to the w all w ith the proper sealant. For models 2010 - 2030, assemble the hood prior to mo u nting,
then mo u nt as described belo w .
12.4.2 Inlet Hood Installation to Air Handler (2005)
First remo v e the hard w are in the top drip edge of the air handler. T u ck the top flange of the hood behind the
top drip edge.
See Page 64, Figure 25
. Replace the hard w are, scre w together the top drip edge of the air
handler, top flange of the inlet hood and the air handler w all panel.
NOTE:
After installing the inlet hood, all hard w are m u st be tightened w ith a torq u e w rench. The roof, side and
bottom seams m u st be ca u lked (s u pplied by others).
12.4.3 Inlet Hood Installation to Air Handler (2010 - 2030)
Inlet hoods are assembled onto the air handler. For Models 2010 and 2010B
See Page 46, Step 12.2.1
. For
Models 2020 and 2030 See Page 55, Step 12.3.1 .
FIGURE 25: Inlet Hood Positionin g
Moisture Limiter
Side Cover
Outer Support Rail
Place the moist u re limiter frame side co v er to the flange at the
top o v erlaps the top of the frame. Attach to the inlet hood drip rail
u sing eight TEK scre w s. Attach to the bottom pan assembly and
top w ith t w o #10-24 x ½" bolts and #10-24 n u ts each. Attach
front stiffeners to the left and right side of the moist u re limiter
frame u sing fo u r TEK scre w s for each s u pport.
Description Part Number
Right Side Co v er 13205079 / 13305079
O u ter S u pport Rail 13205098 / 13305098
TEK Scre w 13404
Air Handler
Inlet Hood