Rapid 2005, Инструкция по установке, эксплуатации и обслуживанию

Страница: 28 / 162

B-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
18 of 147
6.1.3 Liftin g an Upri g ht Air Handler (2005 - 2030)
All air handlers are shipped in the horizontal position.
Prior to lifting an u pright air handler, the follo w ing
steps m u st be performed ( See Page 18, Figure 10 ):
Step 1: The air handler m u st be lifted u sing the t w o
lifting l u gs on the top of the discharge end and the
t w o lifting l u gs on the inlet end, u sing a spreader bar
across the long axis. Lift the air handler off the skid
and place it on a flat, clean, dry s
u rface.
Step 2: Remo v e the lifting l u gs on the inlet end of the
air handler and re-install hard w are.
Step 3: Use all fo u r lifting l u gs on the discharge end
of the air handler to enable the air handler to be lifted
into the
u pright position.
Step 4: Lift the air handler into u pright position.
Step 5: Next, refer to the applicable portions of Page
22, Section 8 for specific mo u nting instr u ctions.
FIGURE 10: Liftin g an Upri g ht Air Handler (2005 - 2030)
Step 1
Remove These
Lifting Lugs
Step 2
Step 3
Step 4
Spreader Bar
I N LET
I N LET
I N LET
I
N
LET