Rapid 2005, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 162

SECTION 3: C
RITICAL
C
ONSIDERATIONS
9 of 147
3.2 Pur g e of Supply Duct
If this heating u nit is to be installed indoors, and its
o u tdoor air s u pply d u cted from o u tdoors, ANSI
Standards Z83.18 and Z83.4 req u ire that all s u pply
d u ct shall be p u rged a minim u m of fo u r times prior to
any ignition attempt. If the v ol u me of the o u tdoor air
s u pply d u ct exceeds the heating u nit’s ability to
complete the req u ired fo u r air changes prior to
ignition, yo u m u st contact the factory to p u rchase an
extended p u rge card of the appropriate d u ration to
meet this req u irement.
3.3 Hardware
Unless other w ise specified, all hard w are m u st be
torq u ed to settings on Page 9, Table 1 .
Note: Inlet hood opening shall not be installed w ith
inlet opening facing into the pre v ailing w ind direction
in order to help pre v ent the possibility of moist u re
entrainment.
Table 1: Recommended Tor q ue Settin g s
Bolt Head
Grade Markin g
Nut Grade
Markin g
Bolt Size Grade 2 Grade 5
10-24 27 in•lb 42 in•lb
1/4-20 65 in•lb 101 in•lb
5/16-18 11 ft•lb 17 ft•lb
3/8-16 19 ft•lb 30 ft•lb
Bolt Head
Grade Markin g
Nut Grade
Markin g
Bolt Size Grade 8 . 8 Grade 10.9
M5 6Nm 9Nm
M6 10Nm 15Nm
M8 25Nm 35Nm
M10 50Nm 75Nm
M12 85Nm 130Nm
M16 215Nm 315Nm
8.8
10.9
8.8 10.9