Rapid 2005, Инструкция по установке, эксплуатации и обслуживанию

Страница: 65 / 162

SECTION 12: I
NLET
H
OOD
55 of 147
Step 12.3.1
Air Handler
Air Handler Top Panel
Horizontal Mount
Horizontal Mount
Without
Filter Section
Air Handler
With
Filter Section
Inlet Hood
Horizontal Mount
Horizontal Mount
Inlet Hood
Filter
Box
Air Handler
Without Filter Section
Without Filter Section
Air Handler
Filter Box
With Filter Section
With Filter Section
External Support
SIDE VIEW SIDE VIEW
TOP VIEW TOP VIEW
Upright Mount
Upright Mount
For an air handler without a filter section: On the inlet of the air handler, install horizontal and u pright
mo u nts. The mo u nts w ill be installed v ia angles open to w ards the o u tside of the air handler.
For an air handler with a filter section: First, attach the filter section to the air handler. Then, bolt the inlet
hood horizontal and u pright mo u nts to the inlet of the filter section w ith the angles opening to w ards the
inside of the filter section.
Upright mo u nts (P/N 13X05090) are attached w ith se v en 3/8-16 bolts (P/N 20517) and flat w ashers (P/N
20515) each; the recei v ing ri v -n u t (P/N 91120106) w ill be factory installed on the air handler or filter section.
Horizontal mo u nts (P/N 13505091) are attached u sing nine TEK self-tapping scre w s (P/N 13404).
Prior to installing the mo u nts, seal the gap bet w een the mating s u rfaces of the air handler/filter section and
the mo u nts w ith the pro v ided foam tape (P/N 92700017).
When installing the top horizontal mo u nt directly to the air handler w itho u t a filter section, foam tape sho u ld
NOT be u sed. In this case, the hard w are on the lip of the air handler roof panel sho u ld be remo v ed, the
mo u nt slid u nder the lip and hard w are re-installed. Foam tape to be u sed on remaining three sides.
To install inlet hood on an exterior w all, drill holes e v ery 8" (20.3 cm) in the flanges of the inlet hood and
mo u nt w ith lag bolts (pro v ided by others).