Ranger R745, Инструкция по установке и эксплуатации

Страница: 7 / 68

R745 Swing-Arm Tire Changer
7
P/N 5900171 — Rev. C — Dec. 2019
Tire Changer components include:
•
Turntable
. Holds the Wheel and has the Wheel Clamps on it.
• Wheel Clamps . Hold the Wheel in place.
• Tower . Holds the Swing Arm. Comes uninstalled.
• Swing Arm . Holds the main tool, the Mount/Demount Head. Moves to the right up to 90 ° when
not needed or in the way.
• Mount/Demount Head . Mounts and demounts Tires. Located on the bottom of the Shaft. The
Tire Changer comes with an alloy steel Head. A plastic, non-marring Head is available.
•
Shaft
. Moves up and down; controls the position of the Mount/Demount Head.
• Shaft Cap . Moves the Shaft down to get the Mount/Demount Head to the desired height.
• Shaft Lock Handle . Locks the Swing Arm in the desired position.
• Swing Control . Stops the Swing Arm from moving past a specific point you choose.
•
Bead Breaker
. Breaks the Beads of Tires so you can demount them. Located on the right side
of the Tire Changer. Includes a Handle a Blade, and a movable mechanism.
• Bead Lifting Tool . Basically a Tire Iron that you use to pull the Bead edge of a Tire over the
Mount/Demount Head so the Tire can be demounted from the Wheel. Can also be used to hold
down a Tire Sidewall during Tire mounting.
• Inflation Gun with Pressure Gauge . Adds air to a Tire. The Pressure Gauge shows the
amount of air pressure currently in a Tire or the amount of air pressure in a Tire as the Tire is
inflated. Includes an Air Chuck with self-gripping clip and an air-dump button.
• Lube Bucket . Holds Tire lubricant. Use a lubricant approved by the Tire manufacturer for the Tire
being changed.
• Lube Brush . Applies the Tire lubricant.
• Bead Breaker Foot Pedal . Moves the Bead Breaker Blade in.
•
Clamps In Foot Pedal
. Moves all four Clamps in (if they are out).
• Clamps Out Foot Pedal . Moves all four Clamps out (if they are in).
• Turntable Foot Pedal . Rotates the Turntable. Press down to rotate the Turntable clockwise,
press up to rotate the Turntable counter-clockwise.
• Regulator/Filter . Controls the pressure of the incoming air supply and removes water from the
incoming air.
• Lubricator . Adds lubrication to the incoming air for tools on the Tire Changer that need it.
•
Voltage Switch
. Switches the Tire Changer’s motor between 110 VAC and 220 VAC operation.
Use with
caution
(refer to Connecting to Power for detailed information). The Tire Changer
comes from the factory set to 110 VAC and the Power Cord has a 110 VAC Plug.
• Replacement Parts . Extra Air Line parts, yellow plastic pieces for the Mount/Demount Head,
and replacement parts for leaking Foot Pedals, in case they are needed in the future.