Ranger R745, Инструкция по установке и эксплуатации

Страница: 16 / 68

R745 Swing-Arm Tire Changer
16
P/N 5900171 — Rev. C — Dec. 2019
Anchoring the Tire Changer
The Tire Changer has holes for anchoring it in place; anchoring is optional.
Note
: You are not required to anchor your Tire Changer. BendPak Ranger recommends doing
so, as the Tire Changer uses force at various times during the changing of a Tire.
Anchoring it ensures it will not move during operation.
The Tire Changer has four .5 in / 12.7 mm holes for anchoring, one at each corner of the base.
On the front of the Tire Changer, the Anchor Bolt holes are partially under the Turntable Foot Pedals.
Not necessarily to scale. Not all components shown.
The Anchor Bolts (sometimes called Wedge Anchors) mentioned in the following procedure are
not
supplied with the Tire Changer. You could, for example, use 3/8 in wide by 3 in deep Anchor Bolts to
secure the Tire Changer, drilling the hole approximately 2.5 in / 63.5 mm into the Concrete.
To anchor the Tire Changer
:
1. Make sure you are wearing OSHA-approved (publication 3151) Personal Protective Equipment:
leather gloves, steel-toed work boots, back belts, hearing protection, and ANSI-approved eye
protection (safety glasses, face shield, or goggles).
2. Make sure the Tire Changer is in the desired location.
3. Using the holes as guides, drill the holes for the Anchor Bolts.
Go in straight; do not let the drill wobble. Use a carbide-tied drill bit (conforming to ANSI B212.15).
Use a drill bit that is the same diameter as the Anchor Bolt. So if you are using an 3/8 in diameter
Anchor Bolt, for example, use a 3/8 in diameter drill bit.