Ranger Products BendPak P-6, Инструкция по установке и эксплуатации

Страница: 13 / 32

13
2. Install the 90 degree hydraulic fitting in the pressure
port of the power unit. The pressure port is covered with
a plastic plug.
3. After the fitting is installed correctly, connect the 140”
hydraulic hose making sure to not over-tighten.
( For below grade hose installations a 1-1/4” hole should
be drilled through the floor at the base of the power unit
so the hose can be routed below grade. )
4. Connect the other end of the power unit hose to the
fitting marked “IN” on the flow divider. (See Fig 5.1)
5. Connect the two remaining equal length hoses to the
flow divider. (See Fig 5.1)
3/8” I.D. tubing may be used rather than the hose provid-
ed as long as it is rated for 3,000 PSI operating pressure
with a 12,000 PSI burst.
STEP 6
( Power Unit Installation )
1. Have a certified electrician run the power supply to
motor. Refer to the data plate found on the motor for
proper power supply and wire size.
NOTE :
The standard power unit can be run on either 110V or
220V. It is already wired for 110V and equipped with
a 3-wire power cord with grounding plug. For optional
220V hook up, follow the wiring instructions as shown
on the motor data plate. See electrical data below.
Line Voltage Running Amps Circuit Breaker
110/115 V 11.6 25A
208V 6.4 30A
230V 5.8 30A
IMPORTANT!
Always use a separate circuit for each lift.
Be sure to use proper circuit breakers or time delay
fuses to protect circuit.
CAUTION!
Check with building plans prior to drilling
any holes in floor.
WARNING!
Risk of explosion. DO NOT install the power
unit inside or near a paint booth. This equipment has
internal arcing or sparking parts which should not be
exposed to flammable vapors.
WARNING!
Motor should NOT be located in a recessed area or
below floor level. NEVER expose motor to rain or other
damp environments. DAMAGE TO MOTOR CAUSED
BY WATER IS NOT COVERED UNDER WARRANTY.
Fig. 5.2