Ranger Products BendPak P-6, Инструкция по установке и эксплуатации

Страница: 7 / 32

7
STEP 1
( Selecting Site )
Before installing your new lift, check the following.
1. LIFT LOCATION : Always use architects plans when
available. Check layout dimension against floorplan
requirements making sure that adequate space is
available.
2. OVERHEAD OBSTRUCTIONS : The area where the
lift will be located should be free of overhead obstructions
such as heaters, building supports, electrical lines etc.
3. DEFECTIVE FLOOR : Visually inspect the site where
the lift is to be installed and check for cracked or defective
concrete.
4. OPERATING TEMPERATURE. Operate lift only
between temperatures of 41° -104° F.
5. Lift is designed for INDOOR INSTALLATION ONLY.
STEP 2
( Floor Requirements )
This lift must be installed on a solid level concrete
floor with no more than 3-degrees of slope. Failure
to do so could cause personal injury or death.
A level floor is suggested for proper use and installa-
tion and level lifting. If a floor is of questionable slope,
consider a survey of the site and/or the possibility of pour-
ing a new level concrete slab.
DO NOT install or use this lift on any asphalt surface
or any surface other than concrete.
DO NOT install or use this lift on expansion seams
or on cracked or defective concrete.
DO NOT install or use this lift on a second/elevated
floor without first consulting building architect.
DO NOT install or use this lift outdoors.
CONCRETE SPECIFICATIONS
LIFT CONCRETE
MODEL REQUIREMENT
P-6 4” Min. Thickness
P-6F 4” Min. Thickness
DANGER!
All models MUST be installed on 3000 PSI concrete only
conformIng to the minimum requirements shown above.
New concrete must be adequately cured by at least
28 days minimum.
TOOLS REQUIRED
Rotary Hammer Drill Or Similar
3/4” ; 1 1/4” Masonry Bits
Hammer
4 Foot Level
Open-End Wrench Set: 1/2””,15/16” - 1-1/8”
Socket And Ratchet Set: 1-1/8”
Medium Crescent Wrench
Crow Bar
Chalk Line
Medium Flat Screwdriver
Tape Measure: 25 Foot Suggested
IMPORTANT NOTICE
These instructions must be followed to insure proper installation and operation of your lift. Failure
to comply with these instructions can result in serious bodily harm and void product warranty.
Manufacturer will assume no liability for loss or damage of any kind, expressed or implied resulting
from improper installation or use of this product.
PLEASE READ ENTIRE MANUAL PRIOR TO INSTALLATION.