Rane TTM57mkll, Руководство пользователя

Страница: 20 / 36

OWNER’S MANUAL
20
TTM57mkII
Deck Inputs 1-2 Control Panel
Analog Input Source
: The analog input for each channel is set for CD (Line level) or Phono level (PH)
using a switch on the rear of the mixer. The control panel shows the input mode selected on the mixer for
each of the four inputs. The mode can only be changed on the mixer.
Phono Sensitivity
: If Phono Input is selected on the mixer, the Phono Sensitivity adjustment appears in
the panel. Click the down-arrow to display a list of 16 sensitivity settings between 2.5 mV and 10 mV in
0.5 mV steps. The default is 5 mV. Set the Phono Sensitivity to the same level of your cartridge (see your
cartridge documentation for the correct value). Another method is to match the level of a CD on another
input.
Filter Resonance
: Each Deck channel has a sweep
FILTER
control that provides a High- and Low-Pass
filter effect. Filter resonance controls the “peak” of the filter cutoff frequency. The Low setting provides the
smoothest Filter without adding gain. The High setting adds accent to frequencies near the Filter cutoff
point by adding about 12 dB of gain. Adding gain in a narrow region around the cutoff frequency adds a
“zip” effect to audio as the Filter is swept. The default is 5 dB.
USB Record Source
: sets PH/CD or AUX as the record source output for digital vinyl simulation (DVS).
Each Deck records to separate USB slots. Deck 1 outputs on USB slots 1-2, Deck 2 outputs on slots 3-4.
• Select Phono / CD for DVS in Serato DJ (default), or to record the Deck pre-fader.
• Select AUX for DVS in Serato DJ, or to record the Aux Input pre-fader.
Tone Crossover
sets the crossover points of the 3-band Tone controls in both Deck channels to either:
• 300 Hz between Low and Mid, 3 kHz between Mid and High.
• 150 Hz between Low and Mid, 6 kHz between Mid and High (default).
Enable USB Insert
connects the signal for the USB FX loop. This is off by default and disabled when
USB is not connected. This is automatically enabled with Serato DJ. Check this box only when you need
to send and return software effects through other DJ and DAW programs.
• Deck 1 FX Send is in USB slots 7-8
Deck 1 FX Return is in USB slots 7-8.
• Deck 2 FX Send is in USB slots 9-10 Deck 2 FX Return is in USB slots 9-10.