Rane TTM57mkll, Руководство пользователя

Страница: 8 / 36

OWNER’S MANUAL
8
TTM57mkII
BOOTH
PHONO
GROUNDS
SEND RETURN
DECK 1 DECK 2 SESSION
100-240V 50/60 Hz 15 WATTS
RANE CORPORATION
OUT IN AUX PH / CD AUX PH / CD
MIC
FlexFX LOOP
USB
MAIN OUT
B A
RIGHT LEFT
MIC
LINE
PH
CD
-10
+4
PH
CD
! !
USB
CD OR TURNTABLE OUT CD OR TURNTABLE OUT
TO MAIN SPEAKERS OR AMPLIFIERS
POWERED POWERED
Quick Start: Hardware
This guide will help you get your decks connected and music playing on one computer. Leave the
power off until your decks and amplifiers are connected.
1. Connect your Left deck’s RCA cables to DECK 1 PH / CD.
• If it’s a CD player, release the CD button next to these jacks so it's out.
• If it’s a turntable, push the CD button next to these jacks so it's in. Secure the ground wire to a Phono
Ground terminal.
2. Set the SOURCE selector for DECK 1 . This lets the left PH / CD 1 deck play directly.
To play from Serato DJ, choose A .
3. Connect your Right deck’s RCA cables to DECK 2 PH / CD.
• Select CD or PH as in step 1.
4. Set the SOURCE selector for DECK 2 . This lets the right PH / CD 2 deck play directly.
To play from Serato DJ, choose A .
5. Connect one of the outputs to amplifiers or powered speakers.
• Main Out is on a pair of balanced XLR jacks with pin 2 “hot” per AES standards.
• Booth Out is on a pair of balanced ¼" TRS (tip-ring-sleeve) jacks.
• Session Out is on a pair of unbalanced RCA jacks.
The Main, Booth and Session outputs arrive from the same “Main Mix” signal. Main, Booth and Session
outputs each have their own
LEVEL control. Because all signals are identical, you may use any of these
outputs as the “Main” output if a different cable type is required to your speaker amplifiers.
Rane recommends balanced wiring (3-conductor) for the strongest signal and rejection of hum and
noise. If your cable to the destination is less than 10 feet (3 meters), you can often get away with an
unbalanced cable. See the RaneNote “
Sound System Interconnection ” at rane.com for cable wiring
recommendations.