OWNER’S MANUAL
23
SIXTY-TWO
Deck 1-2 Channel Options Menu
A menu is available for each deck input channel.
Press and hold the
SHIFT
button then press the
CUE
button of an input channel. This menu allows
you to select 1 of 2 USB record sources and set
the resonance of the Filter. Record options are:
• Pre-selector PH/CD 1 input source (required for DVS).
• Pre-selector PH/CD 2 input source.
Move the Beat joystick up/down to highlight the desired record source, then press the joystick
in to keep the selection.
The PH/CD input must be selected for DVS operation.
Resonance is shown on the bar graph, and adjusted with the
TIME
encoder.
High resonance results in a zippy whistle sound with high peaking of the signal at the corner
frequency. High resonance is typically used as an effect. A low resonance settings has no peaking and is
typically used for mixing. Press any effect button or the
SHIFT
button to exit the menu.
Mic Option Menu
Press and hold the
SHIFT
button then press the
HOLD
button to view the Mic option menu.
• Record the Main Mix to USB.
• Record only the Mic to USB.
• Clean Feed:
When Clean Feed is selected, the microphone signal is sent directly to the Main Out and is not present in
the USB Main Record, Booth Out or Session Out. When set for Clean Feed, the Mic cannot be assigned
to FlexFx. If the Mic FlexFx is pressed, the button will blink off to dim.
Mic Bypass Mode
All controls on the mixer are MIDI mappable,
including the Mic sections. If you do not use
the Mic sections, you can independently
bypass the controls so they do not affect
audio, and only output their MIDI changes. This allows you to map the Mic controls to functions in
software, such as effects, and not have to worry about introducing noise in your mix from a floating
Mic input. To toggle Mic Bypass Mode, hold the
SHIFT
button and press the Mic
ON
button to bypass.
The button will start flashing lightly, indicating those audio controls are now bypassed and are only
outputting MIDI changes. The Mic On and FlexFX buttons, as well as the Level, Pan, and Tone controls
are affected by this mode. While bypassed, the FlexFX and Mic On buttons will flash with momentary
button presses, but the LED state cannot be set from software like the side strip controls. Holding the
SHIFT
button and pressing the Mic
ON
button again will exit Mic Bypass Mode, returning the Mic section to
regular operation. The Mic
ON
button will return to the “off” state. Be sure to reset the Level, Pan, and Tone
controls to appropriate values before switching the Mic back on.
Headphone Tone Control
Press and hold the
SHIFT
button then press the
SPLIT CUE
button to call the headphone menu.
Turn the Time encoder up or down to adjust the
tone. For larger steps, you can press the joystick
left/right. When the bar-graph is in the center,
the response is flat. As the control is moved toward Low, low frequencies are boosted and high
frequencies are cut. As the bar-graph moves toward High, high frequencies are boosted and
low frequencies are cut.
… REC PH/CD-1
REC PH/CD-2
FILTER RESONANCE
SHIFT
CUE
RECORD MAIN
RECORD MIC
CLEAN FEED
SHIFT
OVER
CLEAN FEED
SHIFT
ON
BYPASS
HEADPHONE TONE
LOW HIGH
SHIFT
SPLIT CUE
