Page
9
of
23
CP0487
R&G Racing
Unit 1, Shelley’s
Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
Picture 25
Picture 26
FITTING INSTRUCTIONS
PLEASE NOTE THAT BEFORE BEGINNING, YOU WILL NEED A SUITABLE JACK TO SUPPORT
THE ENGINE WHEN REMOVING OEM ENGINE BOLTS. IF YOU ARE NOT COMFORTABLE, HAVE
FITTED BY A QUALIFIED TECHNICIAN. READ ALL STEPS BEFORE PROCEEDING.
•
Begin by removing the upper fuel tank cover panel following the steps below:
o
Remove 4 x 3mm Allen head bolts from the top panel as arrowed in
picture 1
.
o
Once bolts are removed gently pry the panel upwards from the centre of both sides, this
will release 2 x rubber grommets holding the panel in place. Remove and store in a safe
place.
•
Remove the LHS and RHS inner nose panels, for each side:
o
Remove the 3mm allen bolt from the rear of the panel as shown in
picture 2.
o
Remove the 3mm allen bolt from the front of the panel as shown in
picture 3
.
o
To remove the inner panels, you should push forwards to disengage 3 plastic hooks
linking the fairing to the inner panel.
o
Next lift the panel to release the hooks and lift the back upwards to disengage the panel.
o
As an added precaution use a cloth between the panel and fairing panels as shown in
picture 4
when removing.
Carefully manipulate each panel outwards from the top and
remove completely.
•
Starting with the LHS, remove the lower belly panels from the bike. For each side:
o
Remove the 3 x 3mm allen bolts from the underside of the belly pan as shown in
picture 5
.
o
Remove the forward 4mm allen bolt from the underside of the belly pan as shown in
picture 6
.
o
Remove the 4mm allen bolt from the rear of the belly panel found near the foot controls
as shown in
picture 7
.
o
While supporting the belly fairing, remove the 3 x 3mm allen bolts connecting to the
upper fairing as shown in
picture 8
.
o
For the LHS, a breather tube will need to be removed, which can simply be gently pulled
from the securing pipe on the belly pan as shown in
picture 9
.
o
When removing LHS, you will need to make sure the side stand is in the downward
position as shown in
picture 10
to thread the panel over the stand.
•
To access the required engine mount bolts, both fairing panels should be removed, for each
side:
