SYMPTOM
POSSIBLE PROBLEMS SERVICE
Preparing Tool for Operation—Battery/Charger Problems
Normal Stage of Operation
Pre-Combustion/Combustion Stage of Operation
— Fan does not run
—tool LED is off .
— Fan does not run, or
runs slower than normal
—tool LED is red .
— Battery is not charged .
— Battery Terminals or
Magazine battery contacts
are oily, dirty, or corroded .
— Battery is discharged .
— Charge Battery according to Operating Manual .
— Clean Battery terminals . Clean Magazine Battery
terminals as required .
— Charge Battery .
TROUBLESHOOTING
TROUBLESHOOTING
15
— Safety Yoke does not
depress fully—tool
does not operate .
— Tool will not cycle-fan
runs, LED is green .
— Head or Sleeve O-Ring
pinched .
— Fuel Cell is empty .
— Spark Wire out of spark
plug .
— Spark does not occur .
— Contact Authorized Ramset Distributor Sales
Representative for service .
— Replace Fuel Cell .
— Contact Authorized Ramset Distributor Sales
Representative for service .
— Contact Authorized Ramset Distributor
Sales Representative for service .
— Battery does not appear
to accept charge . Green
charger light does not
come on .
— Flashing lights on
charger base unit .
— Inoperative indicator
lights on charger .
— Battery damaged or
cycle life exhausted .
— Damaged charger .
— Damaged Battery
— Try Battery in tool after 3 hours on charge cycle .
If tool LED is green, charger lights are not working
properly . Replace charger, monitor charging time
to ensure Battery has adequate time for recharging .
It’s normal for Battery to feel warm after properly
charging .
— Replace Battery .
— Discontinue use immediately and unplug from
power source . Replace charger and tag or
dispose of charger to prevent accidental reuse
or connection to power source .
— Replace Battery
